Skip to main content
Metro Tunnel

Geotechnical investigations

Just like the landscape above ground has features like hills, rivers and different types of soil, underground Melbourne has its own landscape.

This landscape includes a variety of geological conditions such as hard rock, softer rocks and clays, silt deposited by rivers and groundwater.

Extensive geotechnical investigations have helped us to gain a greater understanding of local geological conditions which assists in planning how the Metro Tunnel will be built.

Over the past two years, more than 270 boreholes have been drilled up to 50 metres deep along the Metro Tunnel alignment.

The samples collected show that the sedimentary rock beneath the city was formed 416 to 440 million years ago.

Core samples

What do geotechnical investigations involve?

At each drilling location, the works involved:

Stage one: Site establishment

Site compounds of varying sizes will be set up to enable the work to be carried out safely. These areas will be reinstated at the completion of each borehole.

Stage two: Service identification

Prior to the commencement of geotechnical drilling, we will undertake non-destructive digging which involves using a vacuum truck to dig carefully into the ground to confirm an area is free of services.

Stage three: Geotechnical drilling

100-millimetre diameter boreholes will be drilled up to a depth of 50 metres to retrieve a core sample which will provide information on ground conditions in the area. Drilling is expected to take around one week to complete at each borehole.

Stage four: Well development

Ground water and other materials which may have entered the well during drilling works will be removed following geotechnical drilling. Well development will typically take half a day but may extend to a full day depending on the amount of groundwater encountered.

Stage five: Groundwater sampling

Groundwater will be pumped from the borehole at a steady, controlled rate and groundwater samples will be recovered. Sampling typically takes a few hours to half a day to complete. Inspections of the groundwater well were carried out every 2-3 weeks for several months to sample groundwater and measure groundwater levels.